We produce elastomer-lined bearings with outer shells of
carbon steel, bronze, 304, 316, and Carpenter 20 stainless
steels, as well as monel.  We also offer non-metallic shells of
linen epoxy to MIL P-15035FBE and fiberglass epoxy
to MIL-P-18177 GEE.

Our bearing linings include buna N., nitrile, neoprene,
silicone, teflon, urethane, viton, EPDM and others.  We can custom mix
 our elastomers for your application from extreme cold service
 to geothermal requirements up to 180 degrees C.

The elastomers used in our industrial bearings are
specially compounded to resist abrasion, and yet are
resilient enough to allow foreign particles to pass between
the shaft and the rubber liner.  This combination will enhance
 the life of both the bearing and the shaft.

Strict adherence is held to tolerance for inside diameter,
 outside diameter, length and concentricity.  We, at
 Palmer Products, Inc., recognize these critical requirements
 must be maintained to compliment the precision
 manufactured into your equipment.

I have personally stood behind the quality of every bearing
that has left our manufacturing facility since 1973.

Len Palmer, Jr. 
President